Connect-Tek USB-16 Bedienungsanleitung PDF herunterladen (Seite 11)

Host High Speed Electrical Test Procedure Revision 1.4

4 Test Procedure

4.1 Test Record

Appendix A contains the test result entry form for this test procedure. Please make copies of the

Appendix A for use as test record documentation for compliance test submission. All fields must

be filled in. Fields not applicable for the device under test should be indicated as N/A, with

appropriate note explaining the reason. The completed test result shall be retained for the

compliance test submission.

In addition to the hardcopy test record, the electronic files from the signal quality, and power

delivery (inrush, drop and droop) shall be retained for compliance test submission.

4.2 Vendor and Product Information

Collect the following information and enter into a copy of the test record in Appendix A before

performing any tests.

• Test date

• Vendor name

• Vendor address and phone, and the contact name

• Test submission ID number

• Product name

• Product model and revision

• USB silicon vendor name

• USB silicon model

• USB silicon part marking

• USB silicon stepping

• Test conducted by

4.3 Legacy USB Compliance Tests

In addition to the high-speed electrical tests prescribed in this document, the host controller under

test must also pass the following compliance tests applicable to the EHCI Host Controller:

• Low speed signal quality

• Full speed signal quality

• Drop/Droop

• Interoperability

Perform all these tests; record the measurements and summarize the Pass/Fail status in

Appendix A.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Keine Kommentare

Connect-Tek USB-16 Bedienungsanleitung Seite 11